Musiclily 12" x 17" Blank Guitar/Bass Pickguard Material Sheet for Customization

cneycney: This was exactly what I needed for making a custom shaped pick guard for my project king v.

I had to cut it with some sheet metal shears because it is thick, normal 3 ply material. Then I filed the edges to a 45 degree angle. So with some simple hand tools, a fella can make any shaped pick guard you want.

United States on Dec 03, 2023

alberto mario: il prodotto sembra buono anche se non l'ho ancora tagliato nella forma che mi serve per il mio basso.

Italy on Nov 27, 2023

Serg LinkeSerg Linke: Nicht schlecht. Aber könnte etwas günstiger sein.

Germany on Nov 26, 2023

Tanner MayTanner May: Worked perfectly! Cut easy and looks professional

United States on Sep 23, 2023

Barry KingBarry King: See image attached. One is mint green, one is ivory. They're the same colour. Disappointed as I wanted an off-white (ie. ivory)

United Kingdom on Aug 15, 2023

Nicolas M.: Le plastique a fait le job, mais je regrette d'une part qu'il n'y ait qu'un seul film de protection (il y en a parfois deux et ce n'est pas de trop !), d'autre part la qualité de surface qui n'est pas parfaite. Je pinaille un peu car c'est à peine visible, mais c'est un fait, j'ai vu meilleure qualité...

France on Jul 19, 2023

OCONHEROCONHER: No es la primera vez que compro sus productos, y hasta ahora nunca me han defraudado.
La calidad / precio es comparable al de otras de más prestigio, y su gran variedad me surte para terminar mis proyectos.
Lo recomiendo!!

Spain on Jul 03, 2023

SterlingM: This was exactly what I needed for my project. It came together with this to craft a custom cover-plate for the Harmony Bobkat I was rebuilding.

If you have a template, tis is really nice material!

United States on May 07, 2023

Jsims4: Do not leave in direct sunlight, it will warp.
Used this to make electronics cover for a bass.
After cutting the shape I left it sitting on my bandsaw table for a few hours. When I came back to get it, the sunlight coming through the window had badly warped the material. No big problem.
There was plenty of material to cut it again.
I know it was my fault, just be advised and don't make the same mistake I did.
High quality material. Cuts and sands easily.

United States on May 26, 2022

orson corson: This was for a pickguard cut out for a strat shaped bass. Two pickup cutouts, some tight radii around the neck and 6 holes for pots and switches. Then the holes were drilled for the pickguard screws –about 1/4” from the edges. It was a chore, but the cuts were clean and the material stayed intact.

I used the Dremel Rotary cutter at low speed and a coping saw blade when things were a straighter cut. If it’s your first time, try it on similar material or use a portion that isn’t on your finished line –for practice. Things can go terribly wrong when the dremel walks or chatters. This can be controlled with technique, but it requires practice. Also a drill bit can get a bit too aggressive on this material near the edge and cause breakout. Plastic bits or a glass spade bit are nice to have and cut without grabbing the material. A Unibit also works well.

There was no chipping of the top layer and the finished product looks as good as anything coming out of a guitar factory these days. Compared to a Sterling or Ibanez pickguard, it’s on par. I got tortoise and pearl green. Both are very typical of the popular instrument wrap on higher end drums or plastic...

United States on Aug 16, 2020