Moen YG0712BN Iso 12-Inch Designer Grab Bar - Perfect for Bathroom Safety and Support

cv3: Moen’s ISO collection of grab bars allows you to have grab bars in your bathroom, without the institutional look of other grab bars. Fit and finish are very good and the method of installation is straightforward, with one important caveat: the ISO 36” grab bar is about a quarter inch shorter than the 36” Moen grab bar that I was replacing. I like the ISO grab bar and intend to keep it, but I will have to replace a wall tile and have anchor holes that are a quarter inch shorter drilled into the new tile.

United States on Nov 16, 2023

Oswalda S. Andre': 👍

United States on Nov 14, 2023

Susan B: Purchased this when we had a new walk in shower built. Very sturdy, easy to grab onto when stepping in and out of the shower

Canada on Nov 09, 2023

DaRo: These are excellent, beautiful chrome grab bars. They are sturdy and the quality is top notch. Easy to install with good instructions. I placed them on the wall to hold when entering or exiting 2 high bathtubs we have in our bathrooms. They are expensive compared to other grab bars but I feel well worth the price looking at the quality of these chrome grab bars.

Canada on Oct 28, 2023

peterz: I was concerned a combo grab/towel bar would be thick and bulky. I chose this product because it looks less like a grab bar than others, and it looks good! Yes the bar is thick(er than a towel bar) but with a towel hanging on it, it looks fine. And the 24” bar has room for a towel and enough bare grab-surface right where I need it. INSTALLATION: you must slide on the caps before the bar, so the caps GET IN THE WAY when screwing in the fasteners. This was a hassle.

United States on Oct 25, 2023

Fred: This matt black grab bar matches our fixtures. It has a nice inside grip that makes it far better than a simple metal grab bar. I would highly recommend this high quality grab bar.

United States on Sep 28, 2023

KenO: Should have taken a photo but it's now mounted on the wall. It is necessary for the installer to remove the mounting flanges from the grab bar. This requires removing 3 small set screws to release the mounting flanges in order to install the snap-on covers that will conceal the mounting screws as well as the set screws. First, be sure to position the bar and make sure it is level and mark the mounting hole locations. prior to removing the mounting flanges. After drilling the holes and securing the flanges with appropriate hardware to insure it will be a solid mount. The 18 inch center to center distance makes it difficult to have all 6 screws hit the wall framing studs which are typically on 16 inch centers. In my case, it was being mounted on an outer wall made of cinder block and concrete anchors were used. If your wall has solid ceramic tile, as was my case, you will need special carbide bits to drill though the ceramic. Regular concrete bits won't do the job!

In my case, this Moen bar was replacing the Moen grab bar that was installed by the builder which did not match our choice of modern matte black faucets and towel bars. The grab bar choice was one, brushed chrome...

United States on Aug 30, 2023

Mikefg: works as advertised

Canada on Jun 22, 2023

SANDY HERON: Installed in my new shower. The grips on the back of the bar provide security that your hand will not slip.

Canada on Sep 23, 2022

Jennie: Looks beautiful and allows the kids to hold onto something sturdy while getting in and out of the tub.

Canada on Mar 15, 2022