VALISY 16" Full Extension Ball Bearing Side Mount Sliding Drawer Slides (2 Pairs)

Kailua: It works well. But so smooth.

United States on Aug 01, 2023

gail otte: Worked great. i now have some very nice slide out in my cupboards

United States on May 10, 2023

R. Higgins: I replaced the broken roller slides that came with my kids bedside table with these. They slide smoothly, and fully extend the drawer out. They can be a little problematic to install if you are replacing existing drawer slides, and have to precisely align multiple drawer fronts within the cabinet. If you're off by more than 1/16" in some cases, it might be very noticeable. The best method I've found is to use a laser level on a tripod to project lines inside the cabinet to get the center mounting locations for both interior slides. After the interior slides are screwed in, I termporarily hold the drawer in the table so the drawer face is precisely positioned in the face frame. I then use the same laser line projection to mark the center mounting points for the drawer slide pieces. Initially, only use just the vertical mounting holes in case you have to make tiny tweeks to the slide pieces. Fully screw down all slide components once everything looks good. Fyi, a typical 1/2" of clearance is needed on each side of the drawer to use these slides.

United States on Aug 17, 2022

Murphy, TXMurphy, TX: The media could not be loaded.  I really like these drawers slides. In order to access my entire drawer, I wanted to replace my 3/4 slides with full-extension slides. I had replaced my slides in my kitchen with soft-close and did not like the resistance it had upon initial opening so I purposely went looking for non-soft close slides and came across these. I decided to buy a couple to try out and they did not disappoint.

Since I have experience with installing slides, it took only a few minutes to swap them out. I will say that I did not like the provided screws because they did not have a flat back. When installing slides, I tend to only use flat back screws for two reasons. They are more secure (more surface area to the slide) and they lay flatter so that it provides more clearance (should you accidently not go in perfectly straight). I ended up using my own screws for that added security and cleaner look.

The slides fit perfectly and worked smoothly. These slides are 1/2" so make sure your drawer is 1" smaller than the opening to accommodate the slide width. I installed the slides to the bottom of the opening and installed the slide insert 3/16" from the...

United States on Oct 16, 2021

Jon Chung: I bought a new bed for my son that came with a couple large under bed drawers attached to it from Living Spaces. Great bed but TERRIBLE sliders. If you did not pull it exactly from the middle it would go off kilter and get stuck so I bought these sliders and attached them to the drawers. Price was the best on Amazon because it was for 2 pairs, i.e., 4 pieces, which means that I could attach it to both drawers with just the one set. Attachment was a bit difficult, not because of the items, which appears pretty standard when compared to how all the others attach, but because getting everything aligned JUST RIGHT to get the gaps on all sides of the drawers for even clearance was a pain in the rear. I'm sure it's a lot easier with more experience. But back to the sliders themselves...once installed, these are fantastic! No noise whatsoever. Smooth glide and so much sturdier than what was installed before. The factory ones would only allow the drawers to open 2/3 of the way before stopping so you had to reach under the lip of the bed to put clothes in the back, but these sliders allow the drawer to come all the way out. Also, since they are much stronger than the factory sliders, we...

United States on Oct 31, 2018