Torch Paste: The Original Wood Burning Paste Since 2020 - An Easy and Safe Way to Create Beautiful Wood Burning Art

urvielurviel: Previously tried a scorch marker and it bled really badly, not a crisp line to be seen. Tried this gel yesterday and it looked brilliant! Easy to use and although it's expensive for what you get a little goes a long way. The results are excellent 👌

United Kingdom on Sep 17, 2023

Lana: Easy to use. Good quality and easy burning.

United States on Sep 06, 2023

April Lutz: This worked fabulous! Literally just paint it on and put the heat gun over it. So easy and looks so professional! Can't wait to use again! The bottle is tiny, but will last forever!

United States on Sep 05, 2023

Chelli Ranstead: This works very well, even though I was having issues, as I did not have the appropriate heating device. I was still able to get very decent and accurate coverage when using a stencil cut with my cricut.

United States on Sep 04, 2023

DeeDee: It’s a really good product and it does really work leaving a fab effect. However I would say for the size of the jar you get it’s a bit pricy. You do only need a little for it to work but still, had I realised I probably wouldn’t have purchased.

United Kingdom on Aug 30, 2023

D. Robertson: Used it to burn a stencil into a wood platter for a wedding gift - with name and date. The lower heat gun setting (at 700 degrees) didn't seem to leave a "burn," even after at least 5 minutes. Turning it up to 1000 degrees for about 10 minutes seemed to do the trick, however.

United States on Aug 15, 2023

MelaniechdhMelaniechdh: Je n’ai pas eu de soucis , fais ce qu’on attend de ce produit , je recommande !

France on Aug 12, 2023

mr. opinionated: This was my first venture into wood burning paste.

I love that the application is better controlled unlike wood burning pens that bleed out to surrounding areas even when masked off at times. This goes where you put it and stays there.

I followed the directions on each use, but feel they should stress "thin" coat remaining. If the amount left on the piece is too thick, I have found that it takes a much higher heat setting to even get the wood to start burning. This intern causes other blemishes. I have had dry wood somehow produce water/sap bubbling up from the amount of heat I had to apply to get the paste to burn the wood.

I have revised my method to ensure I get ALL excess paste off the piece prior to removing my stencil. This has had mixed results. It works very well on some items and then on others i am forced to crank up the heat gun to get it to burn. This also browns the surrounding area unintentionally.

I have tried stirring the paste to ensure it was all mixed well. That did not seem to have any bearing on the results as well.

I still like the paste as when it turns out, it is so much nicer looking than the pens.

If anyone has...

United States on Jul 30, 2023

Selina B.: Überschüssige Paste unbedingt gut abziehen sonst wirft sie bläschen beim erhitzen.

Ist schwierig bei kleinen Motiven da, da die Folie, also die klebe Schablone, leicht verrutschen kann.

Germany on Apr 29, 2023

Neoli: Die Anwendung ist super einfach und das Ergebnis mega gut. Drauf zu achten ist, dass man kein zu dünnes Brett verwendet und die Paste nach dem
Einwirken so gut wie komplett abwischt bevor man es einbrennt.

Germany on Apr 20, 2023