Overhead Door Weather Seal - P-Bulb Bottom Design Fits Models

Dave in AL: I purchased this with the intention of stopping wind and rain entry under the garage doors. I had originally contacted the manufacturer of the doors (a well known national company) who had also installed them. They didn't carry them in stock and would have to be special ordered at a very high cost and long lead time.

It was very easy to cut to length and only took a few few minutes to install. They fit and installed like the original seals and worked as I hoped. They have now been installed for a couple of years and still look and work as they did originally.

I highly recommend this.

United States on Nov 06, 2023

E. Stewart: This product comes rolled where the bulb is squished flat the wrong way. When closing the garage door it would kick back because to squish the flattened bulb was too much pressure or it would just fold over on itself. I had to use a heat gun and painters tape to hold it while I shut the garage door and leave it for a day to shape it. I would not buy this one again.

United States on Nov 04, 2023

Linda: Easy to install

United States on Oct 03, 2023

Txcoupe: Perfect replacement for our overhead brand door.

United States on Sep 30, 2023

Claudia: I purchased one of each of the sizes available for both my 2-car garage and 1-car garage doors-both of which were 390 overhead series. the previous owners had done a job on each of the garage doors with occasional bangs and run-ins resulting in dents and bends to the bottom track. This resulted in multiple points of entry into our garage by not just an occasional roach or two, but scroprions, giant red-headed centipededes, and more than one snake. Needless to say, I desperately needed a seal replacement.

The GOOD: I googled how to change out the seal and attempted it two different ways...the actual replacement of the seal into the proper grooves took 10-20 minutes. For one door, I attempted to replace while the groove was still attached to the door and it was slow-going. I unbolted the track portion from the main of the door and it all moved along much quicker. I can now see NO VISIBLE gaps (no light shining through) with either seal. The lengths offered were more than enough for my 2 doors and was able to easily cut off excess with basic scissors.

The BAD: The description notes that this is the updated replacement seal for specific Overhead door series. The P bulb...

United States on May 02, 2018