DURA-LIFT 16" Wide Garage Door Bottom Weather Seal | Foam Strip for Protection Against the Elements

Dr S.: Looks good

United States on Sep 04, 2023

93428x2: The price was good for what was received. Very light weight and easy to apply. Removed the old hard rubber gasket which was very split and cracked. Previous nails were applied properly by not hammering them down too far, left about a 3/16" gap and removed them with a prybar and/or hammer. After removing all the old nails, wiped clean the entire base. Be sure that you are applying the correct side outward and flat area against the garage door. Dura-Lift photo helped. Applied 1" large head roofing nails every 4"-5" with an extra at each end. Keep the gasket straight when applying the new gasket. Be careful to not hammer the nails too deep to avoid puncturing the foam gasket. Once completed trim both ends to get a nice clean tight cut. It took about 35 minutes per garage door, from removal, to complete install. Ordered the 16' roll and applied it to two 7' single car garage doors. Nice clean finish. Great improvement.

United States on Aug 21, 2023

Juan J.: The garage floor foam bottom was easy to cut to fit and install. I used construction glue. Clearly its very durable and should stand up to Florida heat and moisture for years to come. I made the right purchase.

United States on Jul 26, 2023

S. DrassS. Drass: This seal does the job. It fit my old door exactly as intended. The foam rubber makes a good seal on the concrete. Don’t hammer the roofing nails down to hard or they will punch tire the soft foam. More detail: My old door bottom rubber seal had seen better days and it was time for a replacement. On top of that the concrete garage floor had settled in both sides leaving about a one inch gap 50” long on either end of the door. The door itself was still square. I cut long shims from a two by four and attached them to the door bottom. I than attached the rubber gasket seal to the bottom of the door with 65 roofing nails spaced about three inches apart. Since I was working alone I used several clamps to support the dangling part of the bottoms seal as I progressed across the door with the tedious nailing. A garbage can/tote made a great rolling tool caddy. The job turned out great and only took a couple hours to attach the seal. Cutting the shims to fit was another story, though. That took a while using my table saw.

United States on Jul 12, 2023

Kevin Morris: The material is strong and, coupled with a new threshold (not included) I haven't had my previous leaking issue with the few rains that have rolled through since its installation.

United States on Oct 20, 2018