AmeriLuck 16.5" Suction Grab Bar with Balance Assist & Indicators for Safer Bathroom Showering

Staci B.: Make sure that the lever is showing green before you grab. If it's in the red, don't you dare. The suction can disengage by itself at anytime

United States on Nov 13, 2023

kfab12: Cleaned the spot where these handles were going to go and stuck them on. It has been several months now and they are still up and very sturdy. They are great and no problems with them falling off.

United States on Oct 12, 2023

carla longstreet: Now what I'll say about this product it was it did do exactly what it said that it would do and it gave me some sense of stability when I was able when I found it was able to get into the shower because it was months before I was able to do to back surgery but let me tell you these things was amazing when the indicator thing came on you know that it was not working it did everything it's supposed to do thank you very much for this product whoever created it Chelsea

United States on Oct 11, 2023

EE: . A bit difficult to install. You have to press onto wall using all your strength. Necessary to install with 2 people, one to push bar against wall and one to push the tabs down.

United States on Jul 18, 2023

Lloyd Tackitt: I bought two sets of two. In each set one of the bars would hold like a miser to money...and the other would fall off in a few minutes. I assume there is a quality control issues at the factory. I looked them over closely and could discern no differences between the hold-fast ones and the let-go ones.

Then I decided to try an experiment. I put boiling hot water in two bowls and set the let-go one's suction cups into the bowls, let them set for about 30 seconds to get hot, then immediately applied them to the shower wall again. Both of let-go ones are now stuck fast and have been for a couple of days, as are the two original hold-tight ones. And I do mean they are very tight on the wall.

So they have gone from a few hours to a couple of days (and still counting) because of that one little hack. I think this works for two reasons.

Reason one is that the heat softens the plastic suction cups which allows them to adhere/align to the shower's surface far better.

Reason two is caused by the heated space in the center of the cup cooling off and creating a strong vacuum.

I used two bowls of boiling water to get both ends hot simultaneously, so that one...

United States on Jan 30, 2023