Westinghouse 7787300 Wall Control for Ceiling Fan and Light Combination

jimmyjo: Great switch for light and fan. 1 side is for the light 1 side is for the fan.

United States on Dec 12, 2023

Ricardo M. G.: Es estéticamente bueno. La calidad precio bien. En funcionamiento. Al menos a mi no me funciona más que nada en la disminución de la luz. Es como interruptor prende y apaga no funciona el desvanecimiento de la luz

Mexico on Aug 02, 2023

Kevin Waites: Dimmer control for light changes the brightness by maybe 10% from full on. Fan speed control to me is backwards. 1 is high speed and 4 is slowest. Seems reversed to what I am used to.

Canada on Feb 26, 2023

Cass: Works well with our 3 wire fan.
Doesn't fun the led bulbs too much, but that could be the bulbs.

Canada on Jun 04, 2022

Snow10: Seems to work opposite, not sure if that was how it was wired. Fast fan speed is actually low.

Canada on Dec 19, 2018

Amazon Customer: They entire mechanism seems well built. I chose this because it is a name brand, Westinghouse. The one part that feels cheap, as others have mentioned, is the fan slider knob on the right side. It has play in its track, but it also takes force to move it into its positions. It is stiff and loose at the same time. It all works and the mechanism fits into a standard wall fixture.

United States on Sep 10, 2018

Amazon Customer: The switch was very easy to install.
The only thing I notice is the slide switch for the light is the higher you move up the brighter it gets but for the fan is the opposite it starts at the bottom on high and the farther up you go the slower it goes

Canada on Jun 18, 2018

SunFun48: I have been searching for a 4 speed fan switch for a long time. This one is very good and includes a dimmer for a fan light. It is easy to install (10-15 mins.). Just 1 wire for the power in and 1 black wire to the fan & a blue wire for the light. The wires are labeled. It is a little bigger than an on/off switch which requires more room in the rear of the box. Used it for 3 days and it works great. The knobs are very small but seem to be fairly durable. However, speed 1 is fastest and speed 4 is the slowest speed which is inverse from what I would have thought. It was priced very good compared to other products which only offered 3 speeds.

United States on May 06, 2016

Motofish: Working well after a couple of days. This switch is kinda nice, it takes one supply wire and outputs to two sources with variable output. So, one hot supply can independently control fan speed and light output. One thing I wasn't expecting is the labels for the fan speeds, (on my switch anyway) 0 = off, 1= high, 2=a little slower, 3 = slower than 2, and 4 = lowest speed. Seemed weird to me. I was expecting 4 to be the highest speed and 1 to be slow, if 0 was off. I didn't wire anything backwards, as the wires coming out of the back of the switch are very clearly labeled. Just a weird operation is all. Other than that the switch seems to work great. If it burns my house down, ill reduce the number of stars... understandably...

United States on May 04, 2016

E. Low: I use these everywhere as I cannot stand pull chains on fans. Don't forget that you'll need to have the four conductor wire in the walls (two hot, one neutral and ground) in order to use this. If you haven't pulled some new cable, you probably won't be able to use this unless you are just replacing an older dual-control switch.
This has no electronics in it like some of the shmancy controls that utilize some form of receiver at the fan. It is dirt-simple and works just fine for me. The sliders are a little stubborn on some of these, but not a huge deal unless your fingers lack bones. Some people are just wimps and like to complain. Ooh, it's HARD to push this little plastic nubby light switch, somebody call the waaaahmbulance! Boo hoo.

United States on Jun 17, 2014