Loctite Plastics Bonding System for Super Glue - Single or Multiple Applications

Jode Tennis: I could not get anything to work at all for what I needed it for. My door handle on my car broke on the inside and I was hoping that this would help fix it and it did not

United States on Dec 08, 2023

Cari Corene: It works for gluing together pla and resin 3d prints, however I will forever curse whoever designed this thing with a plastic cap. After 3 uses, the cap is now welded to the bottle. I didn't even get the second part near the bottle, it kind of did permanently glued itself on it's own. Overall, it works and is strong for small projects. Next time I will plan to use it more quickly than waiting a few weeks between projects.

United States on Oct 04, 2023

KV Trout: What I like about this product is that it is easy to use. Unlike many of the super glues that get clogged up at the tip where the glue comes out, this one does not.
And it lasts quite a while after opening, whereas the others I have used usually do not.

I have used this to repair knick knacks made of resin, and gluing soles into the bottoms of my slippers that would always pop out with my sweaty foot sticking to it.

Depending on what you are gluing, you may have to clamp it or somehow hold it together for an hour or so, and the glue doesn't set completely until after 24 hours. But if it is something that lays flat, or very lightweight, you probably don't have to clamp it.

All in all I like this glue and will probably buy it again.

United States on Mar 12, 2023

Sheikhnbake: Comes with a little sharpie-like primer that you just glide along both edges, and the tube of glue itself, to be applied to only one edge. BE SURE TO USE PROTECTIVE GLOVES. I used ordinary, very thin vinyl ones available for cheap on Amazon. The glue won't hurt you, it's just that it's very difficult not to get it on your hands, dries immediately, and takes at least 24 hours to get it all off if you keep picking at it. Better to get the gloves and avoid that problem. I used it to glue together two panels at the bottom of my car driver's seat: the power seat-control panel on the side, and the adjoining one on the bottom front. I glued two little pegs inserted into holes, plus the seam where the panel meets the front panel. I had to do this because the rear panel at the back of the seat is missing, which normally holds everything in place, so the entire assembly was hanging down. Now it seems to be holding pretty solidly. I glued them together about three weeks ago. I'll give an update in if and when it ever comes apart again.

United States on Nov 10, 2022

Helen Lee: I really don't like to give bad reviews but sometimes it's helpful for others to know your experience with a product. I wanted a 2 part epoxy glue. The double barrel push tubes are messy and wasteful so I wanted 2 separate tubes that I could control the flow and then mix. It's hard to find this now for some reason. As careful as I tried to be reading the description on this product it was not 2 part epoxy. It's hard to see what you are doing and it is basically a surface prep and a super glue. The prep has a felt tip (like a magic marker) and maybe okay for a flat surface but it you want to get into a crevice you can't tell if you have since it is colorless and dry (ish). You put it on both surfaces. Then you put the second part on one surface after a minute. It's like super glue in that you have an instant bond with no opportunity for repositioning. I bought two packages since I thought it was what I needed. After using a tiny dab from the first package the lid on the part 2 tube became stuck fast. I could not even break it free with needle nose pliers. Since I was ready to use it that moment I pricked a hold in the side to at least get one more application. A...

United States on Feb 20, 2020