LENOX Tools Bi-Metal Speed Slot Arbored Hole Saw with T3 Technology for 1-1/2" Holes - 1772729

erick: Work in telcoms. This little guy makes my life so much easier its not even funny. Metal, wood, fiberglass, plastic. There is nothing this little guy can't go through. My heart skips a beat when i can't find it.

United States on Apr 30, 2023

Seamus: Much better design & price than available in stores

United States on Dec 28, 2022

erick: I dont know about the center pilot guide but be prepared to replace those. As for the teeth on this thing i cant be happier. Im notching multiple pieces of 1.5" DOM .120 wall and it makes nice work of it when using some tap oil too

United States on Sep 12, 2022

Léo Talbot: Done a lots and lots of electrical and plumbing in my house and I like to make clean hole. 1 1/2 (38mm) isn’t good for me. This thing is useless since the 1 1/2 inch ABS is way bigger even in is inside diameter. Should have check size before ordering, 1 1/2 ABS is 50mm OD and 40mm ID.

Canada on Mar 20, 2022

DeLongDeLong: Cut almost 50 holes in pine wood and still going. Easy to eject the wood piece with a flat bar (I had a pair of scissors laying around, but a flat head screw driver would work better). It gets hot after a few holes so I let it cool for a minute after cutting 2 or 3 holes. Hasn't failed yet!

I used a hand drill at first and took my time. I later switched to a drill press, still going slow, but it worked better and faster. Just let the saw do the work or you'll burn your wood (like I did a few times being impatient). It took about 1 minute to get through 1.5 inches of pine without burning, jerking, or splintering. Going faster resulted in varying degrees of the above ailments.

The sticker will shred off, but the important information is engraved in the metal.

The saw did grab my workpiece a few times. It's best to just scratch the wood with it first rather than plunging it in. Also, when getting to the end of the cut, go slower and with lighter pressure for a splinter free hole (using a sacrificial board, also). This saw will go through at least 1.5 inches (standard 2x4) in one pass.

United States on Mar 10, 2021

Cliente de Amazon: muy bueno tanto para madera como para metales no muy gruesos yo lo uso para instalar chapas en puertas de tablero de lamina de acero y me funciona bien sin problemas

Mexico on Feb 24, 2021

Bob: I tried to use this bit to drill holes in a metal horse trough.I am not saying it was the bit's fault, but I got tossed around and have bruises where the drill hit me before it unplugged itself and turned off. I did get one hole drilled and decided to drill holes in the lighter weight metal planters/buckets. It worked fine. I decided to tackle the big trough again, and managed to get one more drainage hole finished. I was pretty much over getting tossed around, but my kid bravely took on the task. The saw hole drill bit broke before she finished drilling one hole. We put a plain metal bit in the drill and drilled multiple small holes to finish the job. By the way, I did read all the instructions, and I have used a battery powered drill successfully for years. I gave this bit only three stars because I think it should have worked for more than a dozen holes before it snapped.

United States on Feb 13, 2021