Kelica 35mm IAPMO/CUPC/NSF Certified Replacement Faucet Cartridge (N35DW)

Charles Berube: Cartouches de rechange chinoise à bas prix fuient, commander seulement cartouche approuvée CSA

Canada on Nov 10, 2023

jean-pierre groleaujean-pierre groleau: en premier je pensait que ca ne fonctionnerais pas vue que quand j’ai faite un test juste avec ma pogner vue qud ma pogner est lourde mes un coup instalé avec la pression d’eau toute est
Good

Merci

Canada on Oct 29, 2023

Rick: Faucet was leaking needed a new cartridge a direct replacement for a Belanger faucet was very expensive not sure why so high priced but decided this version would work fine measurements were the same & most important sealing pattern was the same anyway replacement cartridge arrived a day earlier that expected & 10 minutes later we were all good no more leaks & works great

Canada on Oct 23, 2023

David C.: Ad is misleading! Looks like two but is only one!

United States on Oct 12, 2023

Jon: Didn't take even two minutes to install. Fixed the leak we had from the previous cartridge (it was old). Product was as advertised.

United States on Sep 18, 2023

Evan: These look good quality. Work well. And better prices.

United States on Aug 15, 2023

Tso3930: I installed the parts right away after I got it in my mailbox. It’s worth to wait . I know it would take a lot sooner if there’s no virus out there . Thanks all the people involved in this hard work!

Canada on Jun 24, 2020

SimpleGuy: item is as described except it does not have those black letters printed on it; installed and works as original, so far so good. Beware: ordered November 4, received December 8.

Canada on Dec 08, 2019

RobinBRobinB: This product wound up being a sufficient replacement for the cartridge in my AquaSource Faucet (Also Glacier Bay model 65710N-B8427H2). I measured my existing cartridge and found the numbers to be nearly an exact match, the only measurement that was slightly different was the diameter of the two alignment "nubs" that keep the cartridge oriented properly when seated. My existing nubs were more like 3.5mm diameter instead of the 4mm listed in the drawing in the description for this product. The spacing between centers of the nubs was an exact match. My initial attempt at installation led to the cartridge causing leakage out of the faucet when I turned the water supply back on - the slight diameter difference was enough to cause the cartridge to stand off of its intended sealing surface, not allowing the rubber gasket to seal properly. I was afraid that I was going to tighten the metal lockring (that secures the cartridge) too hard to get a better seal, possibly rounding off the flat wrenching surface of the lockring, so I took a flat file to the nubs to remove a tiny bit of plastic material to slightly decrease their diameter. After that, the cartridge felt as though it seated...

United States on Dec 31, 2018

GreenThumb: So far so good, we actually installed this and it didn't solve our low flow issue. However, we needed it anyway as the hubby broke the original cartridge (so then we had low flow and a leaking faucet!) when we took apart the faucet to try and figure out why the flow was suddenly so low. He though he could take the cartridge apart to "clean it" and that didn't work out so well as he broke a tab that keeps it sealed together so use our experience and don't try to do that! FYI, Price Pfister is sending us a replacement cartridge free of charge but will take 7-10 days so we'll just keep that one as a backup. So, in the end we put this cartridge in, no more leaks but still low flow. Another reviewer mentioned the hose, so we disconnected the hose from under the sink (that was fun - nearly got a divorce over that experience) and just "cleaned" that end of the hose gently. There's some kind of pressure washer or something at that end of the hose so I cleaned around that piece very gently with one tip of some fine tipped tweezers - and voila - flow restored! I think it was just hard water build up causing that valve or whatever it is called to not function properly. If we had done this...

United States on Apr 19, 2017