KeeYees 60-Piece 5mm Pitch 2-Pin and 3-Pin PCB Mount Screw Terminal Block Connectors

Ed: These terminal blocks works excellent with my Leo Bardnar button box controllers. They just went into the board with ease and was a pleasure to not have to solder the leads into the board. Great product. Very pleased

Canada on May 19, 2023

Ravana: Product quality is acceptable

Canada on Feb 21, 2023

Robert J: These screw terminals fit beautifully in 2.5mm pitch breadboards and protoboards and I would say that the connectors and screws are better than most I've seen. Recommended

Canada on Dec 15, 2022

Carol G.: On most off-brand Chinese modules these parts are usually crap. These are a pleasant surprise. They actually grip wires *tightly* and also have slotted screw heads which makes it much less likely that you will slip while tightening them.

United States on Sep 12, 2022

John Delmerico Jr.: Used to attach wires to a circuit board that I am building

United States on Jul 02, 2022

D. Lefebvre: They work as intended. Very useful on my model railroad for solid, but still easilly detached connections between various PCB mounted electronic bits and bobs. Also great for mounting on or in buildings to attach wires for lighting, so I don't half to desolder delicate LED lead wires every time I want to move a building. They also come in very handy as useful temporary wire connects (sticking both wires that need to be connected in one terminal and screwing it tight).

United States on Feb 16, 2021

Brady: These are exactly what you expect. Be careful about the screws falling out. Tighten them down before moving them around to prevent a screw from falling out.

They are slightly too thick to fit perfectly next to each other on a protoboard. You can jam them in there but they don’t sit completely parallel. On a breadbord they fit perfectly.

United States on Dec 28, 2020

Serge R.: Conforme

Canada on Oct 20, 2020

Amazon Customer: can be used on a breadboard power rails if plugged in at an angle.

Canada on May 19, 2020

Paul M. Eason: Certainly not the "Green-Colored" brand that starts with a "P", but not bad either. The screw slots are a bit odd and don't readily accept a small phillips but do accept a small flat blade. The band that holds the wire in place is slightly narrower than the slot for the wire allowing the wire to get off-center when inserted. Overall, they were inexpensive, slid together to make higher pin-count blocks, and seemed fine in my application. I would recommend them to someone who is building a prototype on a budget.

United States on Feb 05, 2020