Greartisan DC 12V High Torque 10RPM Electric Micro Speed Reduction Gear Motor

Robert McEwen: Does what it needs to do, works well with a PWM motor controller. Much quieter than the worm drive variant, but comes at the downside of it being much larger in the axis of operation.

United States on Oct 21, 2023

Fran TaborFran Tabor: I will be using this 12vdc 5RPM with a concentric shaft (not the offset shaft), for a pool water solar heater unit on a gimbal that will track the sun. The gimbal will be virtually frictionless on bearings but fairly heavy. Purchased this motor as a test and am VERY happy with its power and construction. Hopefully the output gear and shaft are bonded fairly well (did not check). Greartisan specs 10 kgcm which translates to 0.72 ft-lbs btw, and 0.16A but no load shows 0.062A @12.0vdc with the rotation being CW with labeled polarity, and reverse polarity works fine and CCW. I wish ALL sellers would actually provide ALL the information, and in that I have provided photos of the internals.

United States on Oct 15, 2023

Joe: Great product

United States on Oct 11, 2023

DaC: Sieht nach Qualität aus und fühlt sich auch so an. Läuft sehr leise und ist kräftig.
Hat ein gutes Eigengewicht, lässt sich super verarbeiten . Wird nicht sehr warm insofern kann man ihn gut in diverse Geräte einhausen (3D-Druck). Macht so den Eindruck als ob man längere Zeit an ihm spaß haben kann!
Geht natürlich auch günstiger aber erst einmal bin ich überzeugt.

Germany on Oct 02, 2023

Len VW - KitchenerLen VW - Kitchener: Great little 12v Motor with Face Mount.
I built a transferable test bracket for multiple setups.
Works well with the ALITOVE 360 watt transformer.

Canada on Sep 05, 2023

Terryp: I bought two of these with different speeds, and I'm very pleased with the quality. They're quiet, have little backlash, and seem to be very well made, especially considering the price. It's nice to have such a wide choice of speeds available too. By the way, these allow speed control by lowering the voltage. The 12V motors operate reliably down to just a few volts if the load isn't excessive.

United States on Aug 03, 2023

Mike Hayes: Unfortunately it stalls on low speed, hence to fast for my application

United Kingdom on Jun 02, 2023

Dub: I have beaten this thing with a hammer, drilled through the shaft for inserting a pin and put it under heavy load countless times. It works, the only gripe I have is the flimsy connectors don't pair with the absolute brick of a unit this is.

United States on Mar 09, 2023

g a.: Bought fora project working ok

United Kingdom on Jan 21, 2023

Io: Lo faccio girare a bassissima velocità e per lo scopo è perfetto e ha un’ottima coppia. A pieno regime è piuttosto rumoroso.

Italy on Jan 17, 2023