AUSTOR Desoldering Pump and 6Pcs Solder Wick (2.0mm/2.5mm/3.0mm Width, 1.5m Length) with Flux for Efficient Desoldering

Bradley de Bruin: This works very good the nozzle does get clogged a little but if you heat it up with the iron it will melt the clogged solder and you're good to go again

Canada on Aug 11, 2023

Yves: OK

Canada on Aug 01, 2023

Mark Massingill: The device works and all the rolls of solder were there. The rolls were packed as sets, if you don't look close it appears there is only one roll of each. I think that's why some are claiming they didn't receive all the rolls. IDK. My order was complete as far as that goes. For the price, I don't expect much longevity from the suction device but so far it has worked quite well for my needs and I am quite satisfied.

United States on Jul 22, 2023

Allumitive.: I fix a lot of guitars and fix circuits that have cracked or broken solder joints and i change pots on Fender solder boards and this tool is perfect It works great I think or at least it has been the strips suck off solder really well and they give you tons of it and the sucker does great job of pulling blobs of solder off the boards so I giving it a solid 5 the price is worth every cent you pay and its decent price does the job and a big thumbs up for me on this tool and even if it does where out or quit working i will buy another because for what you get and what it does and has its paid for itself over a few times already good product thanks.

Canada on May 18, 2023

Levi Wilder: I've only used this once before but it worked tons better than what I had prior to it, large diameter handle section makes it somewhat awkward but not un-usable

United States on May 16, 2023

Scoot.man: Good quality

United States on May 01, 2023

Amazonian: The sucker works great; I am impressed.

However, the solder wicks did not soak up very much solder in my (limited) experience.
Perhaps I should try adding fresh solder to the joints before wicking up the solder, as suggested by some folks.

Canada on Jan 21, 2023

Nolen: These are very easy and great to use! The wick has no issues absorbing solder on surface mount pads, or in through holes. Cleans all the solder up really well! It has flux in the wick and it seems perfectly adequate. The spindle holders easily melt though, especially if you're using the soldering iron close to it.

The solder sucker works well especially if you're using hot air to melt the solder in the through holes, then use the sucker to pull the solder out. Kinda gets jammed up but eventually the excess solder builds up and the metal pin inside grabs on enough to eject it out.

Can't go wrong trying these out if you're new to soldering or just starting out. Most important thing is properly flowing/heating everything and not using force causing pads to rip off the PCB.

United States on Dec 07, 2022

Ilia Adad Infante: Es una buena oferta por estos productos. La ventosa tiene buena calidad, se siente maciza y el resorte es bastante duro por lo que la succión es potente.

Mexico on Oct 24, 2022

Gandilor: I always wondered if these things really worked and were worth the money. I had a very sensitive and important piece of electronics that I needed to do some desoldering on, and I didn't want to take any chances of messing it up, so I purchased this Sucker to have in my bag of tricks just in case, even though I was leery of its value. Well, I was having some difficulty removing some solder from a delicate area, so I pulled this out and gave it a shot because the desoldering wicks just weren't quite enough. Bam! Problem solved. Use Wicks and this Sucker and you should be able to desolder anything!

United States on Jun 12, 2022