6-Inch Deep Reach Aluminum C-Clamp by Shop Fox - D2804

Cliente Kindle: Son muy anchos. NO podrás poner más de 2 en una boca regular de guitarra. PERO, son de alta presión. Si consigues poner una mordaza extra, harán el trabajo.

Mexico on Sep 06, 2023

Joel Castellanos Navarrete: Como herramienta de Luthier para pegar los puentes que queden en el sitio exacto con la presión debida. Con la longitud perfecta.

Mexico on Jul 26, 2023

thousandwatts: Work great and reasonably priced.
PRC product, but a third the cost of you know stew.

United States on Jul 06, 2023

Todd Nickila: need to sand down rough edges but otherwise works as intended.

United States on Jun 15, 2023

Chuck Otto: Lightweight, fits right up in there where its suppose to.

United States on Jun 10, 2023

JOSE: I've been using this since day 1. Good for the value.

Canada on May 03, 2023

Brian Clark: I do guitar repair and this clamp is absolutely essential

United States on Apr 14, 2023

guitar guy: It is a good tool....A bit roughly cast - but it got the job done. Good value for the price. Thanks.

Canada on Jan 04, 2023

Zzyzx: Just to let everyone know, I ordered 4 of these clamps and none have the rough casting problem that was reported previously. Maybe they got the word from the other guy's reviews and tightened up quality control.

The only down side I see from these clamps is that the plastic knob and pad aren;t the best quality I'm seen. I will be carefull not to let anything impact the plastic parts becuase they seem like they could be likely candidates for cracking the plastic.

Six inches is measured from the deepest interior depth of the clamp to the center of the white plastic clamping pad. Max inside width is 2 1/8". The open clearance with the screw fully retracted is 1 5/8".

United States on Jun 14, 2022

M. B.: This deep reach clamp looks good, until you take it out the packet and it feels awful! The reason is it was cast, threaded and put in the packet! They did not take the time to sand the exterior of the fine rough casting surface so it claws at your fingers whenever you touch it! I took a foam sanding block to it and then washed it, it is now smooth and feels nice to pick up and work with, likewise the clamping face on the casting was rough and uneven, so I filed that to as near to level as I could and smoothed the sharp corners, now it’s a useful tool, it’s drawbacks are;
6 inches of reach only applies to the center area of about 3/4 of an inch wide, in practice only 4 1/2 inches is available at full width of the clamp. Also the clamp bolts soft nylon face is very small and needs to be bigger to match that of the fixed surface (the one I filed flatter)
Overall not a bad tool, but either it should be cheaper or finished better in my opinion. Be prepared to do as I did if you buy one or live with it as is and use gloves when handling it, the uneven clamping surface may still cause you issues, depending on how well your particular one was cast .

Canada on Feb 11, 2022