1/2" Drive Torque Angle Gauge 360° Adjustable Torquemeter Wrench Set by CNWOOAIVE

Mark B: The bent rod that is supposed to act as a stop for the needle doesn't always seem to stay put. It is knurled and seems like it should work but..nope..you'll be starting to torque the bolt and the rod would tend to slip and rotate thus messing up the angle. I had to file flats on the rod so the set screw could get a better and more positive stop. This fix works and makes it a proper tool, without it..frustration...

United States on May 05, 2022

DIY or Die: I had a bit of a problem with the set pin on this product holding the stop arm in place. But it was easy enough to work around. The indicator line wasn't straight but you can still tell approximately it's on target. With angle torque you do not have to be spot on just +- 1 degree is more then good. I'm more disappointed that I could not find a 3/8 drive socket version anywhere online.
Working on 09 mini cooper and 2012 Ram 1500.

United States on Mar 13, 2022

jag: Had 10 head bolts stopped working after 4. Flimsy plastic junk. Don’t recommend. Would not buy again. You get what you pay for on this one.

United States on Feb 14, 2022

Gaia: So I have never used one of these before. Nic the bolt head with a file or use dot of paint when specs call for 90° . I can see this being useful for smaller ° specs as they are harder to SEE accurately. I still nicked my bolts to try this out. The mark on your bolt is still important and will tell you if something went wonky with dial indicator while turning. The clip is useless it appears to screw on but THAT piece is not actually attached to the clip handle-which looks to be designed for wires - has the split end to crimp wires and this is covered in rubber so if you bump it the clip stays where you put it but the piece you screw to the bending arm falls out of the clip! It should be welded to the piece that screws ON - all that hold the arm to the clip is rubber..so not useful.
The magnet is firmly attached to the screw on piece however and can be made to work quite well. I used a much stronger magnet at my anchor sites and went magnet to magnet. I Also used the bendy arm to help brace it. Any bump to the arm will throw off the measurement so you need to stay out of the path your tool will take. Hold the tool towards the turn lightly before setting...

United States on Jan 11, 2022

Albert Campbell: This 1/2" Drive Torque Angle made finishing my head job on my truck fast.

United States on Nov 18, 2021