Syneticusa Retractable Hard Tonneau Cover for 2016-2022 Toyota Tacoma Trucks

cari haman: Bought this for my 2021 Tacoma SR5 (with the bed rail mounts from the factory). There are brackets that slide into the rails to hold the cover rails on. Putting the rails onto the cover was the hardest part due to me putting it together in the bed of my truck by myself but still wasn’t that difficult. It hasn’t rained since I’ve put it on but I did wash my truck by hand and no water got inside the bed.

United States on Dec 18, 2023

Robert Nugent: installation isn't too bad. I was able to do it myself, however, I would recommend having another person help when putting it together. if you are ok with sacrificing about 9 inches of your bed this is a good cover to get. The comparable covers are way more in price and I can't say I had the more expensive one to compare them to this. I can say that I am not disappointed and I am glad I didn't spend twice the price of what I consider to be the same product. It rolls easy and never had an issue. It did leak a little but looking at it I didn't make it tight enough against the bed.

United States on Dec 08, 2023

A Raj: This good overall product and fits well in Tocoma 2021 Doubles Cab. The only challenging part is it requires patience to install and common sense to put together as the instructions is not very much in sequence or as plain and simple as putting together together IKEA furnitures. Otherwise it is good value for money in fact I have observed my gas mileage has improved by 1-2 miles/gal after putting this on, not sure if it was my driving that has changed.

United States on Apr 07, 2022

Steve StevensonSteve Stevenson: This roller cover is a great value. Seems to be well made. The install was a little tough getting it all lined up in the truck bed but not that bad. As another reviewer pointed out, the 4 screws that attach to the cover near the cab are silver and do not look very good since everything else is black. So I ordered some nice black aluminum license plate screw covers. I replaced the silver flat washers with the brass threaded washers that came with the covers. This way you can screw the black cover onto the washer for a secure fit. I used some thread sealer on both the security screws provided by the manufacturer and the caps. I think this made a great improvement in appearance and was really easy to do. I've attached before and after pictures so you can be the judge.

United States on Dec 11, 2019

Dale DeNikeDale DeNike: For the price you can not beat this cover. Instructions suck.
Seller sent the wrong Cannister assembly in the first order and took them over a week to fix.
They answer E-mails but do not seem to know much about the product.

For 2019 Tacoma you will have to remove the TWO Tie down hooks in the front of the bed on the sides.

Lay pieces out on floor, Support the Side rails with the foam from the package,
Slide the Rolling portion of the top into the groove and Bring the rail just past the front of the cannister and screw togehter.
Do the other side the same way.
Lay complete assembly in the truck making sure that your front gasket is not bent under the cannister.
Install Side rail hardware DO NOT TIGHTEN. Use the extra Piece of metal to hold the side rails apart at the back of the cover.
And Adjust and center cover on bed check that the gaps are covered and tailgate close.
Once you are satisfied with the alignment. Have Someone STAND ON THE RAIL and Finish Tightening down the Hardware to get a good seal.

The Drain lines are WAY TO BIG. Go Buy some 1/2 To 3/8" Barb hose reducers and some 3/8 line.
Cut two inches of the...

United States on Oct 24, 2019