QWORK 4-Inch Rubber Eraser Wheel Tool Kit for Power Drill Attachment - Easily Remove Paint, Rust, & Adhesives

Mokotoks: Did not work for use removing old RV decals. Much too slow and questionable results. plastic scraper blades worked better for us and Heat gun is tricky because overheating ares on gel coat is irreversible

Canada on Sep 26, 2023

Don D.: After a 5-minute learning curve I was amazed at how fast I was able to remove 25-year-old numbers off of a boat.

Canada on Sep 11, 2023

Peter Posdziech: See title. Works great on metal

United States on May 22, 2023

Yanis: Article conforme à la description. Livraison rapide. Ne m'a pas semblé s'user rapidement sur l'usage que j'en ai fait, ni abimer la carrosserie (enlèvement de restes d'adhésif de stickers sur les caches plastiques peints d'un réservoir moto)

France on Mar 09, 2023

Amazon Customer: Great for removing sticky residue from vehicles

United Kingdom on Jan 24, 2023

Angel: Pegatinas sobre cristal las quita bien aunque tardas un tiempo y sobre chapa pues eso con la fricción da calor y te lo quita poco a poco pero tardas mucho tiempo

Spain on Dec 11, 2022

M Rude: I used this to remove old windshield seal residue from my car. It worked well.

United States on Oct 25, 2022

Audrey D.: Very easy to use. Takes vinyl stickers off quickly. But if you have a lot to take off make sure you get several of them. They get worn down pretty fast

United States on Jun 20, 2022

Amazon Customer: This removed the old body molding tape and foam properly. Use the tool flat, not tipped on the corner. That causes premature wear. Rotate it 90 degrees to the strip or the work so the material and the glue, is heated from the friction. Then it sticks together and rolls away from the wheel in a blob. Wear gloves. I found it works better without an adhesive remover. A high pressure carwash wand will remove a lot of the foam rubber and make removal of the backing take less time. I did two 1/2" by seven or eight foot strips in about 1.5 hours. I'm over 70 and my back hurt the next day - BUT this is a good buy.

United States on Sep 24, 2021

Be MooreBe Moore: So I purchased 3 different versions of this product... the 3M Stripe Off Wheel (expensive) and the ABN Rubber Eraser Wheel 4in Pad & Adapter. I had to remove 10 year old sun baked 2-layer vinyl lettering from a fiberglass hull boat. (I am changing the name of the boat). The letters were each about 6-8 inches tall. The layer directly against the fiberglass, where exposed to the sun, was splitting and cracking. The 2nd layer against the first layer was not cracking but was also fairly baked on. All three wheels effectively removed both layers of lettering. However, the 3M wheel left the most streaking or smearing of residual color. The ABN one was a very close 2nd place but suffered from lots of wear (like when you erase pencil with a rubber eraser). The rubber in this particular product seemed to be a little bit harder, but not hard enough to mar or damage the fiberglass. Plus the design with the gaps between the stubby squares made for much more aggressive removal of the vinyl. It left almost zero streaking. As you can see in the photo the former name "Audacious" is ghosted in the fiberglass, but is completely removed. It took approximately 90 minutes to remove the lettering.

United States on Oct 16, 2020