MG Chemicals 4902P Low Temp Solder Paste (Sn42Bi57Ag1) - Type T3

Seb: Bien, mais prenez garde, la seringue n'est presque pas remplie.

France on Jul 02, 2023

Dorian C.: Attention à la viscosité de cette pâte, elle est tellement élevée que le produit à du mal à sortir de la seringue.
Plus de problème la pâte étalées, la soudure se fait bien mais elle est un peu difficile à manipuler sans stencil à cause de cette viscosité

France on Jun 18, 2023

ColinColin: Used this to build the small pcb in the photo. PCB and solder stencil was made by PCBWay. Used stencil to apply this solder paste and after assembly I flowed it in a frying pan on a gas ring stove. Worked beautifully. Would buy again.

United Kingdom on Jun 07, 2023

Kent: I recently discovered the joys of hot air soldering. It's so much easier!

United States on May 25, 2023

Kaleb maestri: Perfect product

United States on Feb 22, 2023

Robin Engström: It seems to be melting at a low temperature. I would rather use low melt solder sticks but they seem difficult to get a hold of, but this works fine in its stead - however it is a bit messy.

Sweden on Aug 05, 2022

Enrico Maria Oggioni: N/A

Italy on Jun 01, 2022

Sergio S: It was really easy to use for a first timer like me. I was able to repair a rear window defrost

United States on Apr 04, 2022

Kurt Goszyk: I needed something that last several months. But when completely sealed, it tends to dry out and not melt evenly.

United States on Feb 09, 2022

chad gabrielson: Very good worked great for my project

United States on Feb 18, 2020