Kaisiking Heavy Duty Black Aluminum Dent Puller Handle Lifter for Car Dent Repair - Suction Cup Remover

crystal: Does not work on dents that have a deep curve in them, these “suction cups” need a flat surface to be able to work which is tricky for most dents

United States on Nov 01, 2023

Amazon Customer: It is very tiny. Also not at all suck the car surface. If only it sucks then we can pull and correct the dent.
It is waste of money and I had to return it

India on Nov 03, 2022

Shehan: Doesn’t work!! Don’t waste your money on this. The suction isn’t strong enough to fix dents on vehicles, even the minor ones.

Australia on Sep 15, 2022

Ronit Thakur: Very poor product , size is too small ,not same as mentioned in details

India on Sep 08, 2022

Karla Gochenour: I’m not sure if it was user error or if they just weren’t a strong enough suction to pull a dent. I WILL say, it looked like it was working everytime before they popped right off

United States on May 20, 2022

BillBill: Can't believe this worked so well! I had this dent in my truck for years and when I finally got around to getting a repair estimate, I was quoted $600. I figured I would try this cheaper alternative first, and thankfully I did. I poured hot water on the dent for 10 seconds and tried the big suction cup. I didn't work and provided little suction. Then I used a small suction over the center of the dent and slowly pulled back and BAM! It was good as new.

United States on Oct 18, 2021

JoanneJoanne: I'm very pleased with the performance of these gadgets. The key is that the whole perimeter of the suction cup must be in contact with the surface. So they just won't work for some projects. I used just the two small black cups and probably could have gotten out that last little bit of the dent if I'd had an even smaller one, or if I had been more strategic about the initial placement. It did take repeated pulls. I used boiling water from a kettle, poured slowly over the affected area twice. Total time invested was under 15 minutes.

United States on Sep 20, 2021

MARMich: I accidentally dented my clothes dryer by balancing a knee on top of the dryer while changing a light bulb. This is an aesthetic problem - the dryer works fine despite the dent. I figured that I may be able to pop the dent out with a suction cup puller. So, I took a chance and ordered these. I cleaned the metal surface of the dryer first with soap and water and then with rubbing alcohol to ensure a clean surface. The small suction cups worked very well and were very strong. The large orange suction cup would not stick to anything. My husband and I tried multiple surfaces, and it was as if the rubber underside would not bend in a concave fashion so that the cup could actually make a suction seal on a hard, flat surface. Long story short, the small suction cups were not big enough to pull out the dent, and the orange suction cup was defective. Needless to say, the dent in my dryer is still there and serves as a daily reminder for me not to be an idiot and use my expensive appliances as a step-stool.

United States on Dec 26, 2020