Genuine Toyota Antifreeze Gallon - 00272-1LLAC-01

RuntheMountain: I usually use the concentrate with distilled water after the old coolant is flushed and runs almost clear. Then I add the concentrate for a 50/50 mix and use a mix using the leftover to fill the overflow tank. Driven 700 miles since the flush and no problems.

United States on Sep 13, 2023

Chris Channell: Works as it should.

United States on Aug 17, 2023

ABOUBEKER DIAKITE: good value for money spent

United States on Jun 09, 2023

jDizzle: its what Toyota recommends for my vehicle. You have to mix it with distill water. I use 50/50. This one gallon actually mixes to 2 gallons. If you buy pre-mix which is little more you only get one gallon

United States on Jan 13, 2023

Jeremy H: It's DARK red and I believe to be genuine Toyota coolant. Used it in 2012 Camry SE with 4 cylinder motor. Flushed the system using 6 gallons of distilled water. Then drain. Topped off with 1 gallon of Toyota antifreeze and more distilled water. Makes a 53/47 mix.

Directions for 2012 Toyota Camry SE with 4 cylinder engine

Tools needed: Small pliers, 1 gallon of Toyota Antifreeze, 7 Gallons of Distilled water, catch pan and 4 feet of rubber hose around 1/8 inch inside diameter or similar. (Optional: 10mm socket and ratchet to remove plastic air dam under radiator. I didn't do this, but some find it easier to reach the radiator drain valve)

1) On COLD engine, remove radiator cap and set it to the side (you won't need it again until the end of project) Then open the drain valve on the bottom of radiator using pliers.

2) Let the radiator drain out.

3) Close the drain valve finger tight.

4) Fill radiator with Distilled Water.

5) With Radiator cap off, start engine and run until warm, paying attention to adding more distilled water as the air escapes and the water level drops. Be sure to turn on the heater, so water can circulate through...

United States on Nov 06, 2019