DURA-LIFT Ultra-Life MAX 2" Sealed 6200ZZ Bearing Nylon Garage Door Roller - Heavy-Duty Performance and Longevity

DavidDavid: I've attached a photo of what I believe are the 25 year old original basic metal rollers after removed from the my existing and probably original garage door. The upgrade to these 6200ZZ nylon rollers gave a "night to day" improvement. I'd used Blaster lubricant on the old rollers and other friction points previously without much improvement, but could not really appreciate the poor condition of the old rollers until removed. I highly recommend replacement of certainly very old rollers with these 6200ZZ nylon rollers. Product as described and illustrated with secure, prompt mailing.

United States on Sep 27, 2023

Ken W: The first 10 roller replacements went well. I removed the hinges and replaced the 20+ year old metal rollers, discovering that the bearings had worn down and had become loose. I thought I would not get the bottom ones done since the brackets were under cable tension and I wasn't going to risk an accident. I then saw a video that suggested removing some of the track supports and twisting the bottom to free the old rollers and slide in the new ones. That worked. When reattaching the track you have to be certain that the other rollers are still in it. I freed three track supports to allow the twisting. May be just doing two on each side would have worked.

United States on Sep 08, 2023

J Porterfield: These were a perfect fit for my garage. It took some muscle to get the wheels out of the track, but once out the new ones slid right in and are much quieter then the old metal wheels! If you can handle getting the old wheels out of the tracks then this is a 10/10 upgrade for any garage. Quieter, smoother operation and inexpensive upgrade to your home.

United States on Sep 08, 2023

Headly: These rollers do the job much better than the original rollers installed when the door was installed.
These rollers will NOT make the door silent..but they WILL help . My garage door actually " screamed " on both opening or closing but theses new rollers have taken that noise away leaving just the loud buzzing of the worm screw as it engages the door.

Also did A full cleaning of all tracks and removal of old dirt and grease and used A spray on Garage door lube on all lift springs and rollers.

Bottom line.... no screaming and new rollers are easy to install.

United States on Sep 06, 2023

mkd: Replaced 10 rollers on a 4 yr old clopay 16 ft by 7' door with the two wound springs on the rod that runs along the top of the door. The 4 rollers on each side starting from the top were easy to change one at a time and i did both sides before looking how to change the bottom roller. The bottom rollers on the Clowpay door have two bolts ,two pins that lock in notches on the end of the door and a stud that the spring loaded cable is attached to. DO NOT TAKE THE BOTTOM ROLLER PLATE OFF UNLESS YOU RELEASE THE TENSION ON THE OVERHEAD SPRINGS AND CABLE!............or ...............DO THIS METHOD AS I DID. ABOUT MID CHANNEL ON EACH SIDE FOUR FOOT OFF THE FLOOR OR SO TAKE A SMALL PLIERS AND GENTLY BEND THE J SECTION OF THE CHANNEL OPEN FOR ABOUT AN INCH OR SO. YOU WANT THE OPENING JUST WIDE ENOUGH THE ROLLER WILL COME OUT FROM BEHIND THE J OR RADIUSED SIDE OF THE CHANNEL. LOOSENING THE CHANNEL BRACKET TO THE WALL THAT IS LOCATED NEAR THAT AREA MAY HELP ALSO. TO SLIDE THE ROLLER OUT OF THE HOUSING RAISE THE GARAGE DOOR TILL THE BOTTOM ROLLER IS LINED UP WITH THE CHANNEL YOU OPENED UP. SLIDE A SCREW DRIVER BETWEEN THE OUTSIDE OF THE ROLLER AND THE CHANNEL AND PRY THE CHANNEL TILL THE...

United States on Jun 05, 2023