Kydex Magazine Holster for In-Waistband and Outside-Waistband Carry - Mag Carrier

Don MattinglyDon Mattingly: Note the position of the magazine in the holster. When you receive a new holster, the screws are not tightened yet as this is a universal holster for different brands. Adjust the screws as needed. You'll first notice that the Shield 9mm's magazine fits in either really tight or quite loose. Note the direct/position of the magazine in its loose state. Then tighten the screws until you get perfection. Holds excellent. Not too tight, not loose at all. Perfect fit and will not come out on its own. Belt clip holds fine.

United States on Nov 30, 2023

C. Good: I was looking for a companion mag holder for my Kydex holster and this turned out to be perfect. It fits like a glove, is compact and quality made. Perfect for conceal carry.

United States on Nov 10, 2023

jas: Fits on belt easily, comfortable, low profile and durable.

United States on Nov 10, 2023

DPT: These are well built for the most part. Belt clip is sturdy, can be flipped around if desired. The molded thermal plastic is clean and shaped nicely.

The downside is the retention, as shipped it was way too loose. I mucked up the phillips heads of the screws trying to tighten them, as when fully tightened the mags will still dump when held upside down, not ideal for EDC. The issue is the rubber washer used for the adjustment is 3/8" and should be 1/8-1/4" sized. My solution was to carefully cut one washers in half and use both halves on the two adjustment screws. Tightened the screws and had perfect retention. Backed them out, added blue thread locker and tightened, now they are good to go.

Due to the DIY aspect, if you are handy and want a project a good buy. Little pricey considering the lift. If you aren't keen on modification, I'd look elsewhere for a p365 mag holster.

United States on Jan 12, 2023

Kathryn: I wanted an IWB ammo holster and researched and tried a number, included highly regarded and established ones like Crossbreed, Gelco, We The People, etc. The Pole.Craft was molded to my gun's magazines, solidly built, worked well, and had an overall thinner profile than the others. On top of that is was available fast and at a reasonable price. Compared to the IWB competition it is 5 stars in terms of doing it's job. But it is not perfect. I just used it for a 4 day defensive handgun training, pulling and holstering countless times all day long. It lacks padding on the inside. Who wants to have a hard Kydex shell pressing against their hip bones all day? After bruising I bought Moleskin at Walmart and added that to the body facing side. Since that is an aftermarket quick fix, it does not adhere permanently, it comes off, and it also peels. There needs to be a better permanent solution, such as neoprene that is permanently glued or screwed on to the holster or something else that adds a few millimeters of padding.

United States on May 25, 2022