Carbide Scraper by Lisle - 5 Inch to 5/8 Inch

George: They are very nice to use, the handles are a bit uncomfortable, but ok. I am still confused as to why the packaging specifies that it may cause reproductive harm / cancer, how exactly ? in which way does one have to use them to achieve those result ? No ideea, and i hope i won't find out.

United States on Sep 03, 2023

Jeremy N.: It's a scraper set, does the job.

Canada on Aug 25, 2023

Kindle Customer: Worked just like they are supposed to.

United States on Jul 24, 2023

Thomas: I have used this extensively for doing an initial scrape for cylinder heads, blocks and intakes. Works well and most importantly is dead flat so if used correctly it doesn't gouge our cause low spots. Its a good tool to have for sure.

United States on Jul 17, 2023

Carlton E Etheridge: Metal is so hard it will chip the corners if you drop them on hard surfaces. This is my second set, they do work awsome other than the pre mentioned.

United States on Jun 22, 2023

Amazon Customer: High quality scraper!

Canada on May 31, 2023

Tdawg: Wish I would of discovered carbon scrapers 5+ years ago these work great and stay sharp for a long time. Y no one show me these? Must be a newer tool/design

Canada on May 15, 2023

Gary R.: I am learning when they are ideal for the job but some of my other methods are still king for some situations. These work great for cleaning up after thick gaskets have been chiseled off. If anyone has worked on Honda out board engines (and I suppose automotive) with the green gaskets you know what I mean by chisel off. For chiseling off I use short bladed putty knife or a thick stiffer scraper made for this with a sharp edge ground at an angle on the top of the blade. With the scraper laid as flat as I can I use a small brass hammer to chisel off the thick gasket. I will come behind the chisel process with these to scrape down to bare metal. These also work good for cleaning corrosion off of gasket surfaces. I don't normally use the powered surface processes because on aluminum and narrow cast iron it is too easy to round off the edges and also glaze over the gasket reminiscence and make it look like the metal surface without noticing it if it is a dark gasket. There is no one tool that does it all.

United States on May 01, 2023

Steve G: Must have tool for cleaning engine surfaces and brake caliper slides

Canada on Mar 02, 2023

MAES: Nicely presented scrapers, machining of the carbide tips is a little inconsistent, slightly out of square on both tool tips. That said it doesn’t seem to affect the tools performance and the carbide tips have held their edge.
Excellent job removing hard baked head, water pump, sump gaskets etc on older vintage components. These are instant time savers,
comfortable quality plastic handles allowing less physical effort.

Australia on Dec 30, 2022