Bora NGX T-Square Accessory - Perfect Addition to Your NGX Clamp Edge System

K. DeYoung: Simple, easy to use, helpful, accurate t-square.

Ignore reviews about how it makes the track roll over. The attachment comes with a plastic tab accessory that is designed to keep the square upright on the work surface so you can still cut past it with your saw.

Only real drawback is it is kind of a pain to add/remove from the track.

United States on Jul 22, 2022

Polo: Easy to attach and use. However, it shipped without the support finger which holds the piece in place when it the L position. In that position without it the entire square is useless. I contacted the manufacturer, they shipped missing part.

United States on Feb 14, 2022

ron st.hilaire: I like the accuracy of the connecting part ! As I mentioned aclamp to hold the end piece and you are off to the races. I would buy again!

United States on Jul 20, 2021

Chin Heng Neo: -

Singapore on Apr 05, 2021

Eric Armstrong: I'm guessing it's good for *something*. I'm just not sure what.

I bought the Bora NGX 50" clamp & saw guide to use as an inexpensive track saw,
so I could cut down 4x8 panels at the yard into 4x4 sections that would fit in the
van. So far, so good. That combination works pretty darn well.

The cool thing about the NGX clamp, too, is that it adjusts from the clamp side,
rather than from the opposite side, like the previous version--which would have
had me walking back and forth from one side of a panel to the other.

I thought that adding the T-square would let me set a mark on one side, set the
clamp, and I would be good to go. Wrong!

The issues I ran into:
1) When the clamp isn't attached in the MIDDLE of the T-square, it's difficult to
ensure that the T-square is fully engaged on the other side. (I found out to
my chagrin that it is all too easy for the T-square to be OUT of alignment, when
a lot of it is projecting out to one side.

2) THINKING the T-square was aligned on the other side of the panel gave me a
false sense of security. I cut a good 1" to one side of the line at the other end.
That may be...

United States on Mar 22, 2021

Kaw1011: it's not perfectly accurate but it works fine for breaking down sheet goods to be re-sawn later on a table saw.

United States on Dec 03, 2020

Normand Matte: Doesn’t align at accurate 90. Probably because it arrived bent. It’s gotten to the point that I can’t be bothered sending items back.

Canada on Sep 02, 2020